2005 Alpine SpeedCut Express Pull-arm Saw

2005 Alpine SpeedCut Express pull arm saw, model 650H.  From OEM literature:  “Saw uses information created with truss design software, featuring automatic set up for both length and angle for every piece. On-screen graphics show the orientation of the lumber while the saw sets up for the next cut. Machine movement occurs after the blade is returned to a safe position behind the fence.  Minimum angle is 5 degrees and the maximum angle is 135 degrees.  Maximum scarf cut is 22 inches.  Setup is digital.  Angulation and length measure are powered.”  Includes 5 HP motor, 16″ diameter blade, 12″ wide x 20 foot long infeed and 12′ x 10 foot long outfeed conveyors and a manual.  Computer operating system is Windows 2000, not supported by Alpine, but saw can be run in manual mode.  480 volt, 3 phase, 15 Amp electrical required.  The computer requires 120 volt, single phase electrical service. 80 PSI at 7 CFM air required.