New floor truss stackers by Spida, handle from 14’ up to 50′ long spans with two stationary pedestals. Trusses travel along the conveyor until they hit the striker plate which starts the stacking cycle. Stack arms retract by 3 1/2″ each cycle. Lift arms reposition for the next truss. Electro-mechanical drive controlled by radio frequency, sensors, and/or touchscreens (with on-screen diagnostics). Can be set up for multiple stacks of trusses inline (on the same side), or opposing sides of conveyor. Optional ability to stack floor trusses two-high. Features manual or automated operation, sealed bearings, 4″ drive tubing and e-stop interlock for finish roller. 760 lbs travel capacity with 10,000 lbs total stack load capacity.
Optional conveyors are 4″ diameter x 3 feet long each, with 1″ diameter shafts, (4) baffles and flanged bearings, adjustable in height from 31″ to 33″. Nominal 5 foot on-center spacing or mounted on beds for further safety or gravel installation. Powered conveyor rolls feature 1/4 HP gear motors. Spida conveyor control panel provides overload protection and forward/reverse starters. 460 volt, 3 phase electrical. Other voltages available as options.